Differences

This shows you the differences between two versions of the page.

--- software [2023/01/04 04:22] – holtz
+++ software [2025/05/26 04:45] (current) – holtz
@@ Line 51: / Line 51: @@
 Download [[http://diffractionlimited.com/product/boltwood-cloud-sensor-ii/| Clarity II]] for the Boltwood II Weather Station (under Downloads tab). When starting the software it may complain about a missing file, MCI32.ocx. This used to be included in older versions of Windows, but not in the current version of Windows 10. If you need it you can get a copy from the [[http://www.diffractionlimited.com/forum/forums/boltwood-cloud-sensors.9/| Clarity II Support Forum]] (look for a thread titled Clarity II and Windows 10 - missing file). Put the MCI32.ocx file in the C:/Windows/SysWOW64 folder.
-Once Clarity II launches successfully hit setup and enter the COM port for the Boltwood II (currently COM4, check device manager to determine current COM ports)
+Once Clarity II launches successfully hit setup and enter the COM port for the Boltwood II (currently COM5, check device manager to determine current COM ports)
 Download and install [[https://www.astronomylog.co.uk/focusmax-downloads/| Focusmax 3.8]]. Focusmax 3.8.0.20 was the last free version. Focusmax 4 now requires a purchase/license. AAVSO can send you the installer, or it’s available on the web at the above link (at least as of the time of writing).
@@ Line 59: / Line 59: @@
 In Focusmax, click ‘choose’ next to ‘not connected’. Select the Optec driver.
 Click properties, to set up the focus properties.
-Select the COM port for the focuser. Currently COM5
+Select the COM port for the focuser. Currently COM4
 In March 2021, switched to FocusMax v4, needed for new large format camera. License purchased. IN 2022, switched to FocusMax v5
@@ Line 77: / Line 77: @@
 Set up camera using Advanced button on ASCOM setup.
-Open Servoconfig, setup COMM port, and enter the COM port for the telescope (currently COM 6).
+Open Servoconfig, setup COMM port, and enter the COM port for the telescope (currently COM3).
 Open SiTech.exe, config, change config, misc, select COM Port for the telescope.
 Dome control is usually done through ACP, but low-level checks can be done through ASCOM Dome Control directly.
 Open ASCOM Dome Control, Select dome, and select the MaxDome II driver.
-Click Setup Dome, select COM port (Currently COM10).
+Click Setup Dome, select COM port (Currently COM6).
 Now we should be able to connect to everything. It’s time to tweak the setup.