Stellar Observations Network Group (SONG): SONG in New Mexico

You've loaded an old revision of the document! If you save it, you will create a new version with this data.

=== Dome control ===

Dome control is implemented through software running on a Raspberry Pi. Initial implementation controls dome motors through the Autoscope box with Opto 22 relays, but goal would be to just control the dome relays directly. The Raspberry Pi has a RELAYPlates card with 7 relays, which control shutter direction, shutter power, dome direction, dome power, and watchdog reset. These relays connect the control lines to ground.

The dome encoder gets +5V and ground from the RPi, and receives 5VDC signals from the A and B phases of the quadrature encoder. These are wired into RPi GPIO ports through a level converter that converts 5V to 3.3V.

The home sensor gets +5VDC and ground from the RPi, and receives a signal on a GPIO port that is normally low, but goes high when the home magnet is in proximity to the sensor.

Low-level functions are implemented in the APOAshDome.py module. An ASCOM Alpaca interface was implemented using the templates from the [[https://github.com/ASCOMInitiative/AlpycaDevice|AlpycaDevice]] package.

Software is archived at [[https://github.com/holtzmanjon/APOAshDome]]

Edit summary

Note: By editing this page you agree to license your content under the following license: CC Attribution-Share Alike 4.0 International