dome_control
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| dome_control [2024/02/10 19:43] – holtz | dome_control [2024/02/10 19:43] (current) – holtz | ||
|---|---|---|---|
| Line 24: | Line 24: | ||
| The home sensor gets +5VDC and ground from the RPi, and receives a signal on a GPIO port that is normally low, but goes high when the home magnet is in proximity to the sensor.S | The home sensor gets +5VDC and ground from the RPi, and receives a signal on a GPIO port that is normally low, but goes high when the home magnet is in proximity to the sensor.S | ||
| | Sensor wire | function | circular connector pin | color | level shifter | color| | | Sensor wire | function | circular connector pin | color | level shifter | color| | ||
| - | | | | 1 | wht | | | | + | | |
| - | | red | gnd | 2 | blk | RPi gnd | | | + | | red | gnd | 2 | blk | RPi gnd | | |
| | blk | signal | 3 | brn | level B3 | gry | | | blk | signal | 3 | brn | level B3 | gry | | ||
| - | | grn | +DC | 4 | red | RPi +5V | | | + | | grn | +DC | 4 | red | RPi +5V | | |
| Low-level functions are implemented in the APOAshDome.py module. An ASCOM Alpaca interface was implemented using the templates from the [[https:// | Low-level functions are implemented in the APOAshDome.py module. An ASCOM Alpaca interface was implemented using the templates from the [[https:// | ||
dome_control.1707594181.txt.gz · Last modified: 2024/02/10 19:43 by holtz